Your heat pump is an important part of your home because it delivers year-round comfort. But, like any home comfort system, it’s bound to experience some issues once in a while.

Let’s go over these issues and how much they might cost to repair, so you’ll have some idea before you call an HVAC technician. Some of the most likely heat pump repair problems include:

  • Heat pump won’t turn on
  • Heat pump won’t turn off
  • Heat pump won’t defrost
  • Heat pump won’t cool
  • Heat pump won’t turn on after changing thermostat
  • Heat pump won’t heat

1. Heat Pump Can’t Start

There are plenty of reasons why your heat pump won’t turn on, so we suggest checking all of them. Sometimes they are as painless as correcting a thermostat setting or swapping your air filter.

Here’s what to check:

  • Is your thermostat on the proper setting? If you want cooling, make sure it’s set to “cool,” “auto” and that your setting is lower than the current temperature. If you want heat, it should be set to “heat,” “auto” and your setting should be greater than the current temperature. If you have a programmable thermostat, replace the batteries if the screen looks jumbled or blank.
  • Has the circuit breaker been tripped? Your heat pump won’t be able to operate if it does not have power. Reset the corresponding breaker if it’s facing the outside of the electrical panel.
  • Is the air filter blocked? A dirty air filter is difficult for your heat pump. If you can’t see light through it, it’s time to get a new one.

If these steps don’t correct the issue, you’ll need to call a heating and cooling company like Siloam Springs Heating & AC.

Estimated Repair Cost

This problem can be complicated, so how much it costs to correct it will depend on what’s wrong.

2. Heat Pump Can’t Shut Down

If it’s extremely hot or cold outside, your heat pump may need to run longer than normal to reach your desired temperature.

If the weather is typical, check that your thermostat is set properly and running normally. If the fan setting is at “on,” the blower motor on your air handler will go 24/7. So, it’ll appear as though your heat pump is running all the time. Constantly using the blower can keep humidity levels under control, but it’ll also drive up your electrical bills.

If your thermostat is set properly, there are a few other problems that could be causing your heat pump to run all the time. They include:

  • A new thermostat that isn’t appropriate for your heat pump.
  • A malfunctioning compressor contactor, which controls the flow of electricity.
  • Leaky ductwork.

Estimated Repair Cost

This can be related to a lot of issues, so your heat pump repair cost will depend on the problem and how difficult it is.

3. Heat Pump Can’t Remove Ice Buildup

Occasionally during cold weather, your heat pump will briefly go into cooling mode. This will melt light frost and ice that naturally accumulates on the coils. A heat pump that becomes totally frozen may struggle to heat your home or shut down completely.

Here are a few reasons why this might be taking place:

  • Your heat pump doesn’t have sufficient airflow because it’s blocked by snow, bushes or yard debris.
  • Your gutters are dripping water on top of your heat pump, creating an icy buildup.
  • A part is not working, which may consist of the reversing valve, relays, controls or sensors.
  • The outdoor fan motor is damaged, dying or dead.
  • Your heat pump has a refrigerant leak. This is likely if you’re hearing bubbling or hissing sounds. Or if you discover a sweet, formaldehyde-like odor close to the outdoor unit.

Estimated Repair Cost

Like we talked about before, there are a few reasons why your heat pump won’t defrost. But here are a number estimated costs for some of these issues. Keep in mind your cost may vary based on your heat pump brand, model and the extent of the issue.

  • Replace reversing valve: $200–$600
  • Replace outdoor fan motor: $250–$650
  • Repair refrigerant leak: Depends on the kind of refrigerant your heat pump uses. R-22 Freon is higher priced since it’s no longer being produced.

4. Heat Pump Can’t Produce Cool Air

Just like a heat pump that won’t turn on, a heat pump that won’t cool can be connected to many issues. We suggest checking for:

  • Right thermostat settings
  • Tripped circuit breakers
  • A clogged air filter
  • Ice on your heat pump

If there’s nothing faulty with your thermostat, circuit breakers or air filter, you’ll need help from an HVAC technician to identify a problem with your ductwork or an iced-over heat pump. Like we discussed earlier, a heat pump that won’t defrost might have a problem with its reversing valve, outdoor fan motor or a refrigerant leak.

Estimated Repair Costs

These repair costs are estimates. Your total expense may vary based on your heat pump brand, model and the severity of the concern.

  • Replace reversing valve: $200–$600
  • Replace outdoor fan motor: $250–$650
  • Repair refrigerant leak: Depends on the type of refrigerant your heat pump uses. R-22 Freon is pricier since it’s no longer being produced.
  • Seal leaky ductwork: Depends on house size.

5. Heat Pump Has Trouble Turning On After Changing Thermostat

If your heat pump won’t turn on after altering the thermostat, the problem is probably linked to your new thermostat. While you can install just about any thermostat with a furnace, the same isn’t accurate for heat pumps, especially if you have backup or emergency heating.

You can test your new thermostat by switching the fan mode to “on.” If you don’t hear the blower motor start in your air handler, there’s probably a problem with the thermostat.

A couple other common thermostat problems include:

  • Wiring was done incorrectly.
  • Thermostat isn’t interacting with heat pump.
  • Thermostat is in emergency heat mode, which requires a reset.

It’s wise to have a heating and cooling pro recommend a thermostat and expertly install it. That way, you’ll avoid any compatibility or wiring issues.

Estimated Repair Costs

The cost of professional thermostat installation depends greatly on what type of thermostat you want. While programmable thermostats are less expensive, they lack the sophisticated features and convenience of a smart thermostat.

6. Heat Pump Isn’t Generating Heat

A heat pump that won’t heat is connected to similar problems with a heat pump that won’t cool. We recommend checking for:

  • Appropriate thermostat settings
  • Tripped circuit breakers
  • A dirty air filter
  • Ice on your heat pump

An icy heat pump or leaky ductwork will require the help of an HVAC technician. Ductwork is hard to reach since it’s found behind walls and numerous issues can cause your heat pump to ice over.

Estimated Repair Costs

These repair costs are estimates. Your total cost may vary based on your heat pump brand, model and the level of the problem.

  • Replace reversing valve: $200–$600
  • Replace outdoor fan motor: $250–$650
  • Repair refrigerant leak: Depends on the kind of refrigerant your heat pump uses. R-22 Freon is pricier since it’s no longer being made.
  • Seal leaky ductwork: Depends on house size.

Resolve All Heat Pump Problems Quickly and Affordably with Our Help

Dealing with a malfunctioning heat pump can be frustrating, but not when you contact Siloam Springs Heating & AC. Our pros have been supplying the quality, affordable heat pump repair Siloam Springs homeowners have depended on since 1992. Contact us at 479-308-8176 to request your free estimate now.

Average repair costs are sourced from Fixr, which compiles estimates based on nationwide averages.